My Project

Hi @sbackaer ! The version 1.5 does not have the gateway class. I currently work with the development branch and I didn't use the 1.5 for quite some time; but I think it is enough to remove the mygateway.h include replace the mygateway contructor with a mysensor constructor replace gw.processRadioMessage with gw.process() Take a look at the serial gateway example.

@Dwalt Sure. Here it is on thingiverse: http://www.thingiverse.com/thing:1410004 @mfalkvidd The battery holder is a single holder with two AA batteries. The batteries are ran in series. To be honest, I can't remember where I bought the holders but I like them because they clip on like a 9 volt so you can easily disconnect the battery holder from your project.

@Dylano you cold try to modify this sketch: https://github.com/n3roGit/MySensors_n3ro/tree/master/in_process/Multisensor_PIR_DHT_light_switch_battery its not finished but there is all you need ;)

great project What is the sketch u use?

@AWI Thanks for the info. I didn't see the 8 to 6 pin adapter at first. Do

@flylowgofast I measured how much the NRF draw, it was ~0,8mA. After change I was not able to measure the current because it was to low. I didn't reset he arduino during this test and change. I will recharge the battery and start over again. Thanks everyone

@martinhjelmare Stupid me! Thanks for bringing this up - these issues are so simple, but very easy to overlook. I was about to start pulling my hair out....

OK, I'm starting to understand HSV better - and I've been reading this thread. I understand that Domoticz currently (although gizmocuz states this is due to change) only allows you to change Hue and Brightness (V), but not Saturation. Is there any other way of changing all 3 values, and sending them to a MySensors RGB node (*) - e.g., using V_TEXT (with suitable conversion from HSV to RGB)? (* I'm currently looking at RGB, not RGBW, as I'm using a separate white strip - I've set up a simple sketch with V_RGB, and V_DIMMER for white.)

Hello Anticimex, It's a very good news ! I already produce the software to communicate between 4 nodes. But It seems to be simple to change for MySensors. I think it will be better for the futur. I will earn lot of time. Thank you for your informations

There is my php module for MajorDomo https://github.com/Shagrat2/majordomo-mysensor His contain library for MYSensor phpMS.php, and to extend classes for Serrial & TCP (phpMSCom.php, phpMSTcp.php)

@AWI - haha, i wish i could say its monday morning - doh. Thank you for notising my mistake :)

@Lawrence-Helm Ultra sonic is a distance sensor

@martinhjelmare Yes, that can be the reason. Thanks everyone

@epierre You can use a Peltier element to power this board. Like this one: http://www.ebay.com/itm/TEC1-12706-12V-60W-Heatsink-Thermoelectric-Cooler-Cooling-Peltier-Plate-Module-/121349774916?hash=item1c41029e44:g:mukAAOSwDNdVrg-U

@lafleur said: It would be nice to have a .PDF of schematic, make it allot easier to view than to load a CAD program... Done. Added to the repository and the openhardware page.