Navigation

    • Register
    • Login
    • Search
    • OpenHardware.io
    • Categories
    • Recent
    • Tags
    • Popular
    1. Home
    2. Tags
    3. sensebender
    Log in to post

    • billgoolsby

      Boards manager package does not install Sensebender gateway
      Troubleshooting • gateway sensebender • • billgoolsby  

      1
      0
      Votes
      1
      Posts
      786
      Views

      No one has replied

    • openhardware.io

      💬 Sensebender Micro mk2
      OpenHardware.io • temperature humidity sensebender samd • • openhardware.io  

      37
      3
      Votes
      37
      Posts
      10914
      Views

      alexsh1

      @tbowmo ha ha ha - at least you are still married
    • hek

      💬 FOTA (Wireless Programming)
      Announcements • wireless sensebender fota firmware over the air update over the air wireless programming • • hek  

      130
      0
      Votes
      130
      Posts
      31482
      Views

      badmannen

      @guillermo-schimmel Thanks a lot ! I got it all up and running node a couple of nodes. But now I confused myself . I got an Arduino Nano as a node that also acts as a repeater, what bootloader can I push into that one? I assume anycahnnel and 16MHz should do the trick since it got that crystal attached. And also one thing that is not really clear in my head, I set the "Fuses&Lock bits" with the AVRDudess for my 328P barebone. But do I really need that? . If I load the bootloader in ARduini IDE for example I specify all those settings in the "board.txt" file. Or is that just to tell the IDE what settings is on the chip ? If I clear these two things up I think I got everything sorted now
    • ikkeT

      How to add Sensebender Micro to IDE boards list?
      Development • sensebender micro ide • • ikkeT  

      4
      0
      Votes
      4
      Posts
      2494
      Views

      GizMoCuz

      +1, thanks, was looking for this as well
    • Pierre P

      Sensebender Micro + button
      My Project • sensebender button sensebender mic • • Pierre P  

      27
      0
      Votes
      27
      Posts
      10470
      Views

      alexsh1

      @martinhjelmare Stupid me! Thanks for bringing this up - these issues are so simple, but very easy to overlook. I was about to start pulling my hair out....
    • Bens

      Scetch doesn't want to load into Sensebender Micro
      Troubleshooting • sensebender uploading scetc • • Bens  

      3
      0
      Votes
      3
      Posts
      1343
      Views

      hek

      Do you have the radio connected during upload? What does the self-test say? To start self test connect A0->GND during startup. And have a look at the serial monitor.
    • alexsh1

      Sensebender with LED pulse count from openenergymonitor.org
      Hardware • sensebender led pulse count • • alexsh1  

      14
      0
      Votes
      14
      Posts
      6117
      Views

      tbowmo

      @Sparkman You are right. The pin names on the sensebender, corresponds to the pin names on the arduinos, so the interrupt on D3 is the same as on the arduino.