@sundberg84
I was able to do a photo, so the dallas temp, and le33 "mask" is on the opposite side, I think this is the problem. (in your example pictures they are on the good side)
No worries, I use currently the newbie pcbs for light switching,
I hate to disappoint you @micah but @Mike-Musskopf has got a point:
MQ* sensors are power hungry. You may want to connect everything up to 240V via a small PSU. There is a big thread on mysensors about air quality detection.
DHT is not the best sensor for a battery application. Please check BME280 (pressure, temp and hum) or Si7021 (temp and hum) - these would be my favourite sensors for low power consumption.
Small tip - your Arduino Pros must be 3.3V and not 5V for the battery usage.
@gohan - Dell R710 over here, brought pretty cheaply in the UK tbh. I have a few things running on it as I'm Microsoft trained and certified so i enjoy messing with that kind of stuff. I was once in that field and attempted to get some work but nothing ever came from it (i got sick of hearing "Sorry, you don't have sufficient work experience") so I've ended up back in University studying mechatronical engineering Anyway, that is another topic for discussion, you're welcome to message me anytime for a chat, would be nice
Hi again
I think so to, here is the new code.
Scene_Controller_6_buttons_and_5_Relays.ino
I reduced the relays to 3, and all the devices is in vera, but the relay status update is stile slow / not happing
The scene controller has now child id = 0 and the relays 1-3.
