@shabba
Hi, unfortunately I don't have time and patience for doing BOM's on all of my projects but in this case it's not very hard as the external component count is greatly reduced by using the NRF51822 RF SOC which is a PTR5518 module from Aliexpress. Other than that there is the Microchip touch sense controller - MTCH105 and the usual smd resistors(0603) and caps. Other than that you're not forced to use and solder the onboard dc-dc converter so you don't have to worry about those components - you just need to solder the 3V_EN jumper to use the Livolo 3V output coming from the main relays/power supply board.
Added sketch, which also supports an additional mini PIR sensor. It's what I needed, you can comment to #define out.
Also changed the regulator to a smaller one, which supplies up to 100 milli Amp, which is plenty enough. That way I can keep the circuit smaller on the PCB. Which allows me to create a smaller housing.
@Tmaster What I meant by my previous comment was to tap on the Node name to see what sensors were connected - Had you clicked on TANQUE you would have seen a box pop up below giving you all the children to that particular Node with what value was last updated and when, so you could easily have found out all about your mysterious 13 children.
At least you have it sorted now, but it pays to do a bit of housekeeping in the sketch setup and Domoticz - eg which of the 6 "Unknown" Nodes is the one you want to next have a look at ?
All my Node IDs are set at the Node, and the sketch name labels the Node ID also, the Nodes are named in Domoticz for easy identification.
In the sketch my sensors are numbered sequentially and commented on what they are, so naming them in Domoticz becomes very much easier.
@Ron said in Capacitive Soil Moisture Sensor:
@Puneit-Thukral Thanks. I am not quite sure, so correct me please if I am wrong, but I think I am already using the MiniCore bootloader with platformIO. Or do I need to configure to explicitly use the MiniCore bootloaders? Also I have set BOD to disabled as I read somewhere that no BOD can also save battery.
hi
I'm not sure, but I believe I'm already using the MiniCore bootloader with platformIO. Please tell me if I'm incorrect. Is it necessary to set the MiniCore bootloaders explicitly?