Yeah that does seem to be the case. But I have read that some were having success so I gave it a go anyways...
I can't see me having much time for a while to give this another go, so i'll probably wait until i can roll back to UI5.
Welcome to the club!
Regarding radio's: The RFM69's with a C in the type have a smaller form factor (which is pin compatible with the predecessor RFM12B). The the 'W' and "HW' versions are larger in size and have more programmable pins (which MySensors does not use) but have exactly the same functionality within MyS.
All the footprints on the boards available in OpenHardware.io are for the 'W' and 'HW' versions so I'd go with one of these.
The 'W' uses way less power than the 'HW' which would be good the for the battery life of your nodes. Sensors powered by the grid can be 'HW', but usually, in the house a 'W' delivers enough TX power to get the message across. It might be a good idea to make your gateway with a 'HW'.
Hope this gets you a bit further. Good luck and show us your results!
Thanks for all the info all
But still have the problem with vera3 on ui7
Cribben, I follow the instructions on the my sensor vera plugin and it comes up with ver 1.3 and no lib #
how did you get the new plugin to load
Any help at all would be welcome as ui7 is not too smooth yet.
