This is a simple, low-cost and quick project that can get a high spouse acceptance factor.
Mirror
Remove the led strip from the aluminum profiles.
Cut the aluminum profiles and the covers to appropriate length. I used a hacksaw to cut profile+cover at the same time to ensure the got the same length.
Cut the led strips at one of the cut points using a side cutter.
Remove the old wires (they are too short to reach the box) and solder new wires.
Put the led strip back inside the aluminum profile. Note that there is a small grove at the back for the strip, this ensures that the strip is close to the profile to maximize cooling.
Glue the profiles to the mirror. I used slow-curing epoxy.
Electronics box
Drill holes in the project box for the switch (6mm) and the potentiometer (6mm should be enough but was too tight so I used 8mm).
Drill a 4mm hole for the wires to the led strips.
Upload the sketch to the Arduino
Connect the Arduino and the battery packs and put them inside the project box.
Fasten the project box using double-sided tape.
Big thanks to my wife for letting me use the action photo.
This should work with Domoticz, it's what I intend to use with it. I've received the boards from China and I'm currently working on a version 2 of this board. There are some errors in the design of version 1 that I need to get out. New version will be up shortly.
@NeverDie Thx for appreciating the work done. There will also be an open source part in the future. When and how extensive the open source part will be, remains to be seen. The release of certain information (block diagram, ..., in this post) is related to those open source parts.
There are some OBD solutions, however most of them (in my experience) give back low frequency data put by the car manufacturer on the OBD-bus (CAN, ...). Therefore transients evolving directly from the battery could only be recorded if the manufacturer sends those data accordingly on the bus. Due to the small bandwidth(also because of other car data that have to be sent, ...), such battery data are sent more often once per second or less. Fast battery events (i.e. cranking events, ...) are therefore imperceptible. Unless the manufacturer processes the fast events and then sends them (once per second or less), which is very unlikely if the manufacturer does not market this feature itself. Third parties devices for high frequency sensing costs several hundreds dollars.
In my experience, important battery states (especially the fast ones) are recorded by measuring and processing corresponding data directly on the battery.
I agree with you about the limits related to the communication over Bluetooth. But i think Bluetooth 5.0 will improve a lot. However, WiFi will always remain an important option due to the high data throughput. The combination of both (BLE & WiFi), especially with regard to energy consumption, will gain in importance.
I've updated the docs at home-assistant.io with sketch examples. Look at the light example.
https://home-assistant.io/components/light.mysensors/#example-sketch
It's what I used for testing during development. It adds an RGB sensor/actuator also besides a dimmer, but you can just remove any references to rgb in the sketch.
The dimmer slider will only be visible after turning on the light and clicking the entity in the gui to bring up the more info card.
