This is a simple, low-cost and quick project that can get a high spouse acceptance factor.
Mirror
Remove the led strip from the aluminum profiles.
Cut the aluminum profiles and the covers to appropriate length. I used a hacksaw to cut profile+cover at the same time to ensure the got the same length.
Cut the led strips at one of the cut points using a side cutter.
Remove the old wires (they are too short to reach the box) and solder new wires.
Put the led strip back inside the aluminum profile. Note that there is a small grove at the back for the strip, this ensures that the strip is close to the profile to maximize cooling.
Glue the profiles to the mirror. I used slow-curing epoxy.
Electronics box
Drill holes in the project box for the switch (6mm) and the potentiometer (6mm should be enough but was too tight so I used 8mm).
Drill a 4mm hole for the wires to the led strips.
Upload the sketch to the Arduino
Connect the Arduino and the battery packs and put them inside the project box.
Fasten the project box using double-sided tape.
Big thanks to my wife for letting me use the action photo.
@Nca78 Yes, I was actually thinking using DIP switch (or even more easy to read thumbwheel switch) to give a unique ID to each node! As soon as I receive the extra radio modules I ordered, I'll test that.
@Grubstake I'm afraid you're right! But it's ok to have just a few days of battery life. As I wrote, it might be often disassembled and reassembled.
@tbowmo more out of curiosity, and from someone that just got started on electronics, so please sorry if this sounds like very noob, but, would it not be safer to plug the V_TARGET LED to the +3.3v pin? How do you ensure that the resistor on the V_TARGET will have constant voltage and that will not blow from over voltage if the VCCio pin is depended on the the Motherboard power?
Thank You and nice work
@yoshida hi!
Im not sure where you get that #9 should be A5? Looks right to me. The pin is connected to pin 9, and that is D3.
For a rotary encoder, it depends on your input - but don't you want an analog signal in? In that case you use the analog pins.
Edit: offcourse, if you use a module converting it to digital like described in the the build section you use a digital pin.
This should work with Domoticz, it's what I intend to use with it. I've received the boards from China and I'm currently working on a version 2 of this board. There are some errors in the design of version 1 that I need to get out. New version will be up shortly.
@MiKa
Hi.
oki, in case i'll add some explanation.. I'll be busy for this week but you can simply use the serial gw example from MySensors for getting started, this should work. I didn't need to create a special board in arduino for this board, so if you're using it, you'll need to install&use the mattairtech SAMD21 board definition for the pin mapping.
https://github.com/mattairtech/ArduinoCore-samd
@Samuel235 said:
Just one of many ideas, the possibilties are endless. I'de always go for RGB leds over just white, allows for more customisation while able to still give you the same white as the white leds.
... unless, as in my use case, colors are not needed.
I'm too stingy to pay for the unused dry powder!
