💬 MDMSNode "Lighting"
-
@jeremushka said:
Your system works with phase and neutral wires?
Yes.
Will you make it compatible without neutral as well?
Actually, no. Why do you plan put this into the wall switch area? As for me, i am going to put "Lighting" near the lamp. Wall switch must be as a push button (normally closed). When you press button circuit opens (on short time) and Atmega328 resets and toggles lamp state. It means that "Lighting" always is conneted to the AC line. You can also change lamp state directly from your controller at any time. See picture below.
@kalina : your solution is quite interesting when push button are installed. Yes, i would like to put the system in the wall switch. For the moment, i connect the switch of the house on the arduino. The system is powered by phase and neutral in the garage as behind the switch i had the neutral wire. However, in the house no neutral like on your picture. So, im checking about using leakage current which should be enough to power on the system.... Not sure.
-
@kalina : your solution is quite interesting when push button are installed. Yes, i would like to put the system in the wall switch. For the moment, i connect the switch of the house on the arduino. The system is powered by phase and neutral in the garage as behind the switch i had the neutral wire. However, in the house no neutral like on your picture. So, im checking about using leakage current which should be enough to power on the system.... Not sure.
@jeremushka said:
So, im checking about using leakage current which should be enough to power on the >system.... Not sure.
I would be interested to hear about your results
-
@Kalina, does your project still alive? do you still have some samples for sales ?
@jeremushka This project has some shortcomings. For this reason I have released a new, more advanced version - MDMSNode "Lighting" Rev 1.1. If you are interested, I have more than 10 pcs in stock.
-
@jeremushka This project has some shortcomings. For this reason I have released a new, more advanced version - MDMSNode "Lighting" Rev 1.1. If you are interested, I have more than 10 pcs in stock.
-
@kalina would you mind adding a link to the new version in the description of the old one?
@mfalkvidd Easy)) Already done.
-
@ Kalina: Thanks :) Which kind of shortcomings did you get? load switch issue ? safety issue ?
-
@ Kalina: Thanks :) Which kind of shortcomings did you get? load switch issue ? safety issue ?
@jeremushka Please look at the description MDMSNode "Lighting" Rev 1.1, everything is indicated there...
-
-
This post is deleted!
Hi @aramko-aramko.
Unfortunately, this model is already sold. You can look at the upgraded version of this device - MDMSNode "Lighting" Rev 1.1.
