Damm I am trying to get this working with a Arduino pro mini ,,but no luck wanted to use it in the car ..
How do you wire the NRF24L01+ ???
N-Channel Mosfet s ??? model number please any help much appreciated
I have tried mosfets >>>irf510n
To provide a large enough pulse to drive the ceramic transducer , you need a lot of energy, so they pump up the 5v with an inductor/transformer to provide a high voltage pulse. This is 60v or more…
The more Energy you produce the farther the pulse will travel….
Everything thing else on the board run at 3.3 to 5V.
Add a large Capacitor of 100 µF are so between the 5v and ground on the device, this may clean up your problem.. Some CPU modules just can’t supply enough current quick enough that’s needed when the pulse is triggered.
These are very inexpensive device, we’re luck to see them work at 1/2 the spec range.
@lis610 I have found with a 499K resistor the range is reduced to about 1.2m in a ABS box.
With a 1Mohm it was about 3m, I do not have many high value SMD resistors to experiment with but the lower the value the lower the range.
Just tried with a 333K and it operates about 0.8m in free air.
