@MiKa
Hi.
oki, in case i'll add some explanation.. I'll be busy for this week but you can simply use the serial gw example from MySensors for getting started, this should work. I didn't need to create a special board in arduino for this board, so if you're using it, you'll need to install&use the mattairtech SAMD21 board definition for the pin mapping.
https://github.com/mattairtech/ArduinoCore-samd
Sure, there is already the KiCAD file including everything to play around with on your own; added a picture of the schematic here for a quick glance without downloading.
Hey vivek101
how did you connect the NRF24L01 to your home assistant server? Normaly, you connect the nRF to an microcontroller and flash it with a gateway sketch. Then you connect the uC to your server...
Regards, Edi
Hi,
I finally received the boards from the manufacturer(big thanks to @Seeed-Fusion). I manage to assemble one board by soldering the components and such and...it WORKS(including OTA)! I will post the instructions on openhardware.io project page.
