Well, sure enough we work on sensors but more related to home automation. Industrial automation requires higher quality stuff and usually the sensor types are different.
About other forum start searching "industrial automation forum" there are some coming out, also I bet there are some in your specific country too. Communities are everywhere
Nice work so far @wint0178, great that you try expanding on the examples. Sorry for the late reply.
If you look at https://github.com/mysensors/MySensorsArduinoExamples/blob/bba998bce09bc5139eb4ca7a05b0279f4083ff88/examples/PressureSensor/PressureSensor.ino#L90 you see where the existing child ids are defines. You just add another one for the gas sensor, with a unique number (incrementing by 1 is an easy way).
Try that and report back on your result. If something is unclear, just post a followup.
@hek I have two sensors in my network ( temp , Hum ) and motion detection. both working in auto mode and request node id from controller ( raspberry pi ) node via gateway . but unfortunately, reponse code of both nodes get same node id 1.
may be bug in sendNextAvailableSensorId() function response.
any idea?
thanks
@Yveaux said in serial, Ethernet to MQTT:
Of course, but MySensors MQTT gateway runs just as fine when connected over cabled ethernet, as when connected over wifi
I do not know that
Now on this tool, I do not see much benefit from ethernet to MQTT
Still, it is good from serial to MQTT.
