Hi!
Going through examples and forum topics I've noticed that I'm using the wrong S-type and V-type.
I'm writing a new version of the code with S_LIGHT and V_LIGHT so there is now dimmer functionality (which I don't need).
Let's see if this helps.
@yveaux said in Ikea Molgan Hack:
@magpern the instructions on openhardware.io state that the Molgan must be battery powered while programming:
Well, then I can confirm that you don't have to power the Molgan from batteries just for programming. Burning the bootloader works fine with just power from the ISP port and programming it through FTDI works fine if power comes from the FTDI.
What I found wierd is that the atmega328 had power, the radio had power, it wrote debug messages to the FTDI - when powered through the FTDI, it send radio messages etc, but it just did not receive messages.
Messages where not received until I supplied power to the + / - pads (battery pads).
I did read the instructions on openhardware.io, but I didn't follow then to the t.
@Ron said in Capacitive Soil Moisture Sensor:
@Puneit-Thukral Thanks. I am not quite sure, so correct me please if I am wrong, but I think I am already using the MiniCore bootloader with platformIO. Or do I need to configure to explicitly use the MiniCore bootloaders? Also I have set BOD to disabled as I read somewhere that no BOD can also save battery.
hi
I'm not sure, but I believe I'm already using the MiniCore bootloader with platformIO. Please tell me if I'm incorrect. Is it necessary to set the MiniCore bootloaders explicitly?